案例,spss,数据分析

新型激光无线网络传输控制器的研制


字数:10000字  原创指数:360  类别:案例模板

【内容概述】

新型激光无线网络传输控制器的研制
本系统采用STM32F103V8T6作为控制中心,同时与以太网光纤模块、激光驱动模块、接收放大和限幅模块、电源管理模块等部分协调作用,共同完成以太网激光传输的功能。整个系统通过STM32单片机配置IP113ALF的工作模式等参数、配置MAX3263的驱动功率,并将配置参数存储在EEPROM芯片ATMEL24C04中供IP113ALF上电初始化使用,同时STM32单片机读取接收端MAX3964测到的信号强度,并且可以通过串口和上位机通信。在系统电源电路部分,采用高效率开关电源芯片LM2596-5及其外围器件构成的电源电路提供5V稳压电源,同时采用ASM1117 3v3和ASM1117 2v5稳压器件组成多电压电源系统。
关键词:激光无线传输;以太网;STM32;IP113ALF;PECL
Development of A New Type of Laser and Wireless Network Controller
 
Abstract: The system uses STM32F103V8T6 as the control center, and Ethernet module, driver module, laser receiving amplifier and limiting module, power management module and other parts together to complete the coordination role, Ethernet laser transmission function. Driving power of the whole system by using STM32 SCM configuration mode of IP113ALF working parameters, MAX3263 configuration, and the configuration parameters are stored in a EEPROM chip ATMEL24C04 for IP113ALF power on initialization, signal intensity and STM32 read the receiver MAX3964 detected, and through the serial port and the host computer communication. In the system power circuit, power supply circuit adopting the high efficiency switching power supply chip LM2596-5 and peripheral devices which provide 5V regulated power supply, while the use of ASM1117 3v3 and ASM1117 2v5 regulator composed of multi voltage power supply system.
Key words: Laser wireless communication; Ethernet; STM32; IP113ALF; PECL